Some of the stones will have a shiny layer on both sides or it may be a cutter’s issue in that case when it comes under Headstones manufacturing areas those areas will be last over to make the first phase not shiny. While seeing the interior of manufacturing areas it will have complete machine operating systems because often we cannot move the rocks from one place to another and not only the single worker to work inside and he cannot carry the stone often. So workers will split up their work according to their interest and knowledge and once the person completed their work then they will power on the machine which automatically moves the stones to other work. This cycle of work repeats until the stones and artwork is completed.
First of all, servants will paste out a white paper which holds the design what do the customers expects. And while moving on to the blasting machine it will alter only the non-papered area. Once the monument comes out after the second blast it will have the correct design that is printed according to the software, moves to the final step where the remaining coverings on the stones will be removed from it. And while completion of the third step the names are checked out whether it is printed correctly or not. The rubber that is used above the stone will have correct strength or nice quality in it. Every people would expect that their stones should be stable for more than five to six years without any missing letters in them.
What is the final stage of preparing a headstone?
At every work, there will be an in-charge for their section only after verifying every product with its reference picture they will send it to further work. Some customers would like to have angel images on the stones so in the second blast they would only have a stamp that means the output of the angel image when it comes to the final step the artist will give interior work in detail. Artist work is more important and if they miss out on their concentration from their work there are many chances to cross over the whole image using blades.
Normally even your customer does not ask for any designs you should create some attractive fonts and images on it because the headstone is not designed to keep inside the house it is kept on outdoor where a lot of dead bodies are buried under the earth. And most of the people will be visiting the pace once a week or once or year or daily to get relaxation. By this, you can attract people by adding some additional designs. Check whether your font and designing techniques are used by any other headstone manufacturing company if it is without any doubt you should change your product font or else to raise complaints about the opposite teamwork. While selling out the same products for fewer cost people would prefer only the least rate seller while comparing to your company. When the number of altering work moves on or increases then cost will also rise so check always the complete cost management.